How To Set Up A Dome Tent

A Wilderness Trails dome tent is simple to set up. (Photo: tent in the sunset image by Galyna Andrushko from Fotolia.com )

Dome tents, like those made by Wilderness Trails, are pop amid hikers and backpackers due to their low-cal weight and piece of cake setup. The common features amidst these tents include tent poles that fold upward for easy care, nylon walls, a waterproof floor made from plastic tarp material and a detachable nylon wing with a centre ridge pole. The tents include both stakes and sidewall ropes for increased stability.

Step 1

Clear the footing of any debris that could puncture the tent floor and lay out all parts of the tent.

Footstep 2

Unfold the tent and place it bottom-side down well-nigh the location where you lot programme to stake it. The result is a larger foursquare or trapezoidal piece of plastic tarp with a loose dome of nylon attached to it. The dome department will have a number of nylon sleeves sewn into it where the tent poles are placed. The corners of the tarp will also take a place to attach the ends of the poles.

Footstep 3

Assemble the poles, including the pelting fly ridge pole. Most poles resemble tubes with a slightly larger metal connector at the cease. The tubes are held together by a long bungee cord that is run downwards the center of the entire pole. To get together the pole, place the finish of each tube section into the respective metal joint. The ridge pole will be shorter than the tent poles.

Stride four

Slide each pole into a nylon sleeve, but do not attach it to the corners of the tarp yet. When you accept finished, your tent should resemble a spider's web, with each tent pole criss-crossing in the center of the dome. Attach the ends of the tent poles into the pockets or rings at the corners of the tarp floor. This volition curve the tent poles into an biconvex shape, giving the dome its structure.

Step 5

Move your tent into position. Feel the ground through the tarp floor to make certain that it is free of protruding rocks and debris. Lift a corner of the tent and remove any droppings if y'all need to. Sweep out the interior of your tent with a broom.

Footstep 6

Identify stakes into the stake rings at the corners of your tent floor and hammer them into the ground with a mallet. Secure the sides of the tent past tying 1 side of the sidewall rope to the tent poles. Tie the other terminate of the cord to additional stakes. Pull the ropes taut and hammer the stakes into the footing.

Step 7

Slide the ridge pole into the nylon casing on the rain wing. Place the rain wing over the tent with the ridge of the wing over the doorway. Secure the rain fly to the tent past placing the hooks at the corners of the wing into the loops on the tent designated for the rain fly.

References

Writer Bio

Tracy Morris has been a freelance author since 2000. She has published novels and numerous online articles. Her work has appeared in national magazines and newspapers including "Ferrets," "CatFancy," "Lexington Herald Leader" and "The Tulsa Globe." She holds a Available of Arts in journalism from the Academy of Arkansas.

Source: https://traveltips.usatoday.com/wilderness-trails-dome-tent-setup-instructions-2332.html

Share this post